diff options
Diffstat (limited to 'drivers/net/sh_eth.c')
| -rw-r--r-- | drivers/net/sh_eth.c | 37 |
1 files changed, 36 insertions, 1 deletions
diff --git a/drivers/net/sh_eth.c b/drivers/net/sh_eth.c index 53d918d38..17dd0d281 100644 --- a/drivers/net/sh_eth.c +++ b/drivers/net/sh_eth.c @@ -277,6 +277,7 @@ int sh_eth_recv(struct eth_device *dev) static int sh_eth_reset(struct sh_eth_dev *eth) { int port = eth->port; +#if defined(CONFIG_CPU_SH7763) int ret = 0, i; /* Start e-dmac transmitter and receiver */ @@ -296,6 +297,13 @@ static int sh_eth_reset(struct sh_eth_dev *eth) } return ret; +#else + outl(inl(EDMR(port)) | EDMR_SRST, EDMR(port)); + udelay(3000); + outl(inl(EDMR(port)) & ~EDMR_SRST, EDMR(port)); + + return 0; +#endif } static int sh_eth_tx_desc_init(struct sh_eth_dev *eth) @@ -339,9 +347,11 @@ static int sh_eth_tx_desc_init(struct sh_eth_dev *eth) /* Point the controller to the tx descriptor list. Must use physical addresses */ outl(ADDR_TO_PHY(port_info->tx_desc_base), TDLAR(port)); +#if defined(CONFIG_CPU_SH7763) outl(ADDR_TO_PHY(port_info->tx_desc_base), TDFAR(port)); outl(ADDR_TO_PHY(cur_tx_desc), TDFXR(port)); outl(0x01, TDFFR(port));/* Last discriptor bit */ +#endif err: return ret; @@ -405,9 +415,11 @@ static int sh_eth_rx_desc_init(struct sh_eth_dev *eth) /* Point the controller to the rx descriptor list */ outl(ADDR_TO_PHY(port_info->rx_desc_base), RDLAR(port)); +#if defined(CONFIG_CPU_SH7763) outl(ADDR_TO_PHY(port_info->rx_desc_base), RDFAR(port)); outl(ADDR_TO_PHY(cur_rx_desc), RDFXR(port)); outl(RDFFR_RDLF, RDFFR(port)); +#endif return ret; @@ -532,11 +544,18 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) outl(0, TFTR(port)); outl((FIFO_SIZE_T | FIFO_SIZE_R), FDR(port)); outl(RMCR_RST, RMCR(port)); +#ifndef CONFIG_CPU_SH7757 outl(0, RPADIR(port)); +#endif outl((FIFO_F_D_RFF | FIFO_F_D_RFD), FCFTR(port)); /* Configure e-mac registers */ +#if defined(CONFIG_CPU_SH7757) + outl(ECSIPR_BRCRXIP | ECSIPR_PSRTOIP | ECSIPR_LCHNGIP | + ECSIPR_MPDIP | ECSIPR_ICDIP, ECSIPR(port)); +#else outl(0, ECSIPR(port)); +#endif /* Set Mac address */ val = dev->enetaddr[0] << 24 | dev->enetaddr[1] << 16 | @@ -547,11 +566,16 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) outl(val, MALR(port)); outl(RFLR_RFL_MIN, RFLR(port)); +#ifndef CONFIG_CPU_SH7757 outl(0, PIPR(port)); +#endif outl(APR_AP, APR(port)); outl(MPR_MP, MPR(port)); +#ifdef CONFIG_CPU_SH7757 + outl(TPAUSER_UNLIMITED, TPAUSER(port)); +#else outl(TPAUSER_TPAUSE, TPAUSER(port)); - +#endif /* Configure phy */ ret = sh_eth_phy_config(eth); if (ret) { @@ -562,6 +586,7 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) phy_status = sh_eth_mii_read_phy_reg(port, port_info->phy_addr, 1); /* Set the transfer speed */ +#ifdef CONFIG_CPU_SH7763 if (phy_status & (PHY_S_100X_F|PHY_S_100X_H)) { printf(SHETHER_NAME ": 100Base/"); outl(GECMR_100B, GECMR(port)); @@ -569,6 +594,16 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) printf(SHETHER_NAME ": 10Base/"); outl(GECMR_10B, GECMR(port)); } +#endif +#if defined(CONFIG_CPU_SH7757) + if (phy_status & (PHY_S_100X_F|PHY_S_100X_H)) { + printf("100Base/"); + outl(1, RTRATE(port)); + } else { + printf("10Base/"); + outl(0, RTRATE(port)); + } +#endif /* Check if full duplex mode is supported by the phy */ if (phy_status & (PHY_S_100X_F|PHY_S_10T_F)) { |