diff options
Diffstat (limited to 'board/omap2420h4/mem.c')
| -rw-r--r-- | board/omap2420h4/mem.c | 22 | 
1 files changed, 10 insertions, 12 deletions
| diff --git a/board/omap2420h4/mem.c b/board/omap2420h4/mem.c index 3ce38cc4d..9ae595b3c 100644 --- a/board/omap2420h4/mem.c +++ b/board/omap2420h4/mem.c @@ -74,9 +74,9 @@ void prcm_init(void)  	if(running_in_sram()){  		/* If running fully from SRAM this is OK.  The Flash bus drops out for just a little. -	 	* but then comes back.  If running from Flash this sequence kills you, thus you need -	 	* to run it using CONFIG_PARTIAL_SRAM. -	 	*/ +		* but then comes back.  If running from Flash this sequence kills you, thus you need +		* to run it using CONFIG_PARTIAL_SRAM. +		*/  		__raw_writel(MODE_BYPASS_FAST, CM_CLKEN_PLL); /* go to bypass, fast relock */  		wait_on_value(BIT0|BIT1, BIT0, CM_IDLEST_CKGEN, LDELAY); /* wait till in bypass */  		sdelay(1000); @@ -172,14 +172,13 @@ void do_sdrc_init(u32 offset, u32 early)  	cpu = get_cpu_type();  	/* warning generated, though code generation is correct. this may bite later, -         * but is ok for now. there is only so much C code you can do on stack only -         * operation. +	 * but is ok for now. there is only so much C code you can do on stack only +	 * operation.  	 */  	if (cpu == CPU_2422){  		sdata = (sdrc_data_t *)&sdrc_2422;  		pass_type = STACKED; -	} -	else{ +	} else{  		sdata = (sdrc_data_t *)&sdrc_2420;  		pass_type = IP_DDR;  	} @@ -187,10 +186,10 @@ void do_sdrc_init(u32 offset, u32 early)  	__asm__ __volatile__("": : :"memory");  /* limit compiler scope */  	/* u-boot is compiled to run in DDR or SRAM at 8xxxxxxx or 4xxxxxxx. -         * If we are running in flash prior to relocation and we use data -         * here which is not pc relative we need to get the address correct. -         * We need to find the current flash mapping to dress up the initial -         * pointer load.  As long as this is const data we should be ok. +	 * If we are running in flash prior to relocation and we use data +	 * here which is not pc relative we need to get the address correct. +	 * We need to find the current flash mapping to dress up the initial +	 * pointer load.  As long as this is const data we should be ok.  	 */  	if((early) && running_in_flash()){  		sdata = (sdrc_data_t *)(((u32)sdata & 0x0003FFFF) | get_gpmc0_base()); @@ -344,4 +343,3 @@ void gpmc_init(void)  	__raw_writel(H4_24XX_GPMC_CONFIG7_1, GPMC_CONFIG7_1); /* enable mapping */  	sdelay(2000);  } - |