Merge branch 'qlcnic'

Rajesh Borundia says:

====================
* "qlcnic: Change 82xx adapter VLAN id endian type".
  - Adapter requires VLAN id in little endian. VLAN id was being
    converted to __le16 and then passed as a parameter. Pass VLAN id
    as u16 and then use cpu_to_le16 at appropriate places. It is
    appropriate for net-next as SR-IOV patches have a dependency on it.
* "qlcnic: Fix loopback test for SR-IOV PF".
  - It is appropriate for net-next as change is needed for SRIOV PF
    only.
* Remaining patches add enhancements to SR-IOV functionality like
  - FLR handling
  - Adapter reset recovery handling
  - iproute2 tool support for configuring MAC address, Tx rate and
    VLAN id.
  - Mailbox polling support for SR-IOV PF in case mailbox interrupts
    are disabled.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 50 insertions, 7 deletions

diff --git a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
index d132765f92a..247a9f9b7bd 100644
--- a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
+++ b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
@@ -290,7 +290,7 @@ static int qlcnic_fdb_add(struct ndmsg *ndm, struct nlattr *tb[],
 		return err;
 
 	if (is_unicast_ether_addr(addr))
-		err = qlcnic_nic_add_mac(adapter, addr);
+		err = qlcnic_nic_add_mac(adapter, addr, 0);
 	else if (is_multicast_ether_addr(addr))
 		err = dev_mc_add_excl(netdev, addr);
 	else
@@ -341,6 +341,12 @@ static const struct net_device_ops qlcnic_netdev_ops = {
 #ifdef CONFIG_NET_POLL_CONTROLLER
 	.ndo_poll_controller = qlcnic_poll_controller,
 #endif
+#ifdef CONFIG_QLCNIC_SRIOV
+	.ndo_set_vf_mac		= qlcnic_sriov_set_vf_mac,
+	.ndo_set_vf_tx_rate	= qlcnic_sriov_set_vf_tx_rate,
+	.ndo_get_vf_config	= qlcnic_sriov_get_vf_config,
+	.ndo_set_vf_vlan	= qlcnic_sriov_set_vf_vlan,
+#endif
 };
 
 static const struct net_device_ops qlcnic_netdev_failed_ops = {
@@ -399,6 +405,7 @@ static struct qlcnic_hardware_ops qlcnic_hw_ops = {
 	.config_promisc_mode		= qlcnic_82xx_nic_set_promisc,
 	.change_l2_filter		= qlcnic_82xx_change_filter,
 	.get_board_info			= qlcnic_82xx_get_board_info,
+	.free_mac_list			= qlcnic_82xx_free_mac_list,
 };
 
 int qlcnic_enable_msix(struct qlcnic_adapter *adapter, u32 num_msix)
@@ -895,16 +902,31 @@ void qlcnic_set_vlan_config(struct qlcnic_adapter *adapter,
 	else
 		adapter->flags |= QLCNIC_TAGGING_ENABLED;
 
-	if (esw_cfg->vlan_id)
-		adapter->pvid = esw_cfg->vlan_id;
-	else
-		adapter->pvid = 0;
+	if (esw_cfg->vlan_id) {
+		adapter->rx_pvid = esw_cfg->vlan_id;
+		adapter->tx_pvid = esw_cfg->vlan_id;
+	} else {
+		adapter->rx_pvid = 0;
+		adapter->tx_pvid = 0;
+	}
 }
 
 static int
 qlcnic_vlan_rx_add(struct net_device *netdev, __be16 proto, u16 vid)
 {
 	struct qlcnic_adapter *adapter = netdev_priv(netdev);
+	int err;
+
+	if (qlcnic_sriov_vf_check(adapter)) {
+		err = qlcnic_sriov_cfg_vf_guest_vlan(adapter, vid, 1);
+		if (err) {
+			netdev_err(netdev,
+				   "Cannot add VLAN filter for VLAN id %d, err=%d",
+				   vid, err);
+			return err;
+		}
+	}
+
 	set_bit(vid, adapter->vlans);
 	return 0;
 }
@@ -913,6 +935,17 @@ static int
 qlcnic_vlan_rx_del(struct net_device *netdev, __be16 proto, u16 vid)
 {
 	struct qlcnic_adapter *adapter = netdev_priv(netdev);
+	int err;
+
+	if (qlcnic_sriov_vf_check(adapter)) {
+		err = qlcnic_sriov_cfg_vf_guest_vlan(adapter, vid, 0);
+		if (err) {
+			netdev_err(netdev,
+				   "Cannot delete VLAN filter for VLAN id %d, err=%d",
+				   vid, err);
+			return err;
+		}
+	}
 
 	qlcnic_restore_indev_addr(netdev, NETDEV_DOWN);
 	clear_bit(vid, adapter->vlans);
@@ -1710,7 +1743,10 @@ qlcnic_setup_netdev(struct qlcnic_adapter *adapter, struct net_device *netdev,
 
 	qlcnic_change_mtu(netdev, netdev->mtu);
 
-	SET_ETHTOOL_OPS(netdev, &qlcnic_ethtool_ops);
+	if (qlcnic_sriov_vf_check(adapter))
+		SET_ETHTOOL_OPS(netdev, &qlcnic_sriov_vf_ethtool_ops);
+	else
+		SET_ETHTOOL_OPS(netdev, &qlcnic_ethtool_ops);
 
 	netdev->features |= (NETIF_F_SG | NETIF_F_IP_CSUM | NETIF_F_RXCSUM |
 			     NETIF_F_IPV6_CSUM | NETIF_F_GRO |
@@ -1731,6 +1767,9 @@ qlcnic_setup_netdev(struct qlcnic_adapter *adapter, struct net_device *netdev,
 	if (qlcnic_vlan_tx_check(adapter))
 		netdev->features |= (NETIF_F_HW_VLAN_CTAG_TX);
 
+	if (qlcnic_sriov_vf_check(adapter))
+		netdev->features |= NETIF_F_HW_VLAN_CTAG_FILTER;
+
 	if (adapter->ahw->capabilities & QLCNIC_FW_CAPABILITY_HW_LRO)
 		netdev->features |= NETIF_F_LRO;
 
@@ -2112,6 +2151,7 @@ static int __qlcnic_shutdown(struct pci_dev *pdev)
 	if (netif_running(netdev))
 		qlcnic_down(adapter, netdev);
 
+	qlcnic_sriov_cleanup(adapter);
 	if (qlcnic_82xx_check(adapter))
 		qlcnic_clr_all_drv_state(adapter, 0);
 
@@ -3266,8 +3306,10 @@ int qlcnic_set_max_rss(struct qlcnic_adapter *adapter, u8 data, size_t len)
 
 	qlcnic_detach(adapter);
 
-	if (qlcnic_83xx_check(adapter))
+	if (qlcnic_83xx_check(adapter)) {
 		qlcnic_83xx_free_mbx_intr(adapter);
+		qlcnic_83xx_enable_mbx_poll(adapter);
+	}
 
 	qlcnic_teardown_intr(adapter);
 	err = qlcnic_setup_intr(adapter, data);
@@ -3281,6 +3323,7 @@ int qlcnic_set_max_rss(struct qlcnic_adapter *adapter, u8 data, size_t len)
 		/* register for NIC IDC AEN Events */
 		qlcnic_83xx_register_nic_idc_func(adapter, 1);
 		err = qlcnic_83xx_setup_mbx_intr(adapter);
+		qlcnic_83xx_disable_mbx_poll(adapter);
 		if (err) {
 			dev_err(&adapter->pdev->dev,
 				"failed to setup mbx interrupt\n");