diff options
Diffstat (limited to 'cpu/ppc4xx/4xx_enet.c')
| -rw-r--r-- | cpu/ppc4xx/4xx_enet.c | 72 |
1 files changed, 63 insertions, 9 deletions
diff --git a/cpu/ppc4xx/4xx_enet.c b/cpu/ppc4xx/4xx_enet.c index d990250fc..007cb4f1e 100644 --- a/cpu/ppc4xx/4xx_enet.c +++ b/cpu/ppc4xx/4xx_enet.c @@ -274,7 +274,7 @@ static void emac_loopback_disable(EMAC_4XX_HW_PST hw_p) static void ppc_4xx_eth_halt (struct eth_device *dev) { EMAC_4XX_HW_PST hw_p = dev->priv; - uint32_t failsafe = 10000; + u32 val = 10000; out_be32((void *)EMAC_IER + hw_p->hw_addr, 0x00000000); /* disable emac interrupts */ @@ -290,8 +290,8 @@ static void ppc_4xx_eth_halt (struct eth_device *dev) /* wait for reset */ while (mfdcr (malrxcasr) & (MAL_CR_MMSR >> hw_p->devnum)) { udelay (1000); /* Delay 1 MS so as not to hammer the register */ - failsafe--; - if (failsafe == 0) + val--; + if (val == 0) break; } @@ -308,6 +308,13 @@ static void ppc_4xx_eth_halt (struct eth_device *dev) hw_p->print_speed = 1; /* print speed message again next time */ #endif +#if defined(CONFIG_460EX) || defined(CONFIG_460GT) + /* don't bypass the TAHOE0/TAHOE1 cores for Linux */ + mfsdr(SDR0_ETH_CFG, val); + val &= ~(SDR0_ETH_CFG_TAHOE0_BYPASS | SDR0_ETH_CFG_TAHOE1_BYPASS); + mtsdr(SDR0_ETH_CFG, val); +#endif + return; } @@ -494,11 +501,18 @@ int ppc_4xx_eth_setup_bridge(int devnum, bd_t * bis) u32 zmiifer; /* ZMII0_FER reg. */ u32 rmiifer; /* RGMII0_FER reg. Bridge 0 */ u32 rmiifer1; /* RGMII0_FER reg. Bridge 1 */ + int mode; zmiifer = 0; rmiifer = 0; rmiifer1 = 0; +#if defined(CONFIG_460EX) + mode = 9; +#else + mode = 10; +#endif + /* TODO: * NOTE: 460GT has 2 RGMII bridge cores: * emac0 ------ RGMII0_BASE @@ -520,7 +534,7 @@ int ppc_4xx_eth_setup_bridge(int devnum, bd_t * bis) * Right now only 2*RGMII is supported. Please extend when needed. * sr - 2008-02-19 */ - switch (9) { + switch (mode) { case 1: /* 1 MII - 460EX */ /* GMC0 EMAC4_0, ZMII Bridge */ @@ -703,6 +717,11 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) #ifdef CONFIG_4xx_DCACHE static u32 last_used_ea = 0; #endif +#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \ + defined(CONFIG_460EX) || defined(CONFIG_460GT) || \ + defined(CONFIG_405EX) + int rgmii_channel; +#endif EMAC_4XX_HW_PST hw_p = dev->priv; @@ -836,10 +855,12 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) reg = CONFIG_PHY1_ADDR; break; #endif -#if defined (CONFIG_440GX) +#if defined (CONFIG_PHY2_ADDR) case 2: reg = CONFIG_PHY2_ADDR; break; +#endif +#if defined (CONFIG_PHY3_ADDR) case 3: reg = CONFIG_PHY3_ADDR; break; @@ -1006,12 +1027,17 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) #if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \ defined(CONFIG_460EX) || defined(CONFIG_460GT) || \ defined(CONFIG_405EX) + if (devnum >= 2) + rgmii_channel = devnum - 2; + else + rgmii_channel = devnum; + if (speed == 1000) - reg = (RGMII_SSR_SP_1000MBPS << RGMII_SSR_V (devnum)); + reg = (RGMII_SSR_SP_1000MBPS << RGMII_SSR_V(rgmii_channel)); else if (speed == 100) - reg = (RGMII_SSR_SP_100MBPS << RGMII_SSR_V (devnum)); + reg = (RGMII_SSR_SP_100MBPS << RGMII_SSR_V(rgmii_channel)); else if (speed == 10) - reg = (RGMII_SSR_SP_10MBPS << RGMII_SSR_V (devnum)); + reg = (RGMII_SSR_SP_10MBPS << RGMII_SSR_V(rgmii_channel)); else { printf("Error in RGMII Speed\n"); return -1; @@ -1131,7 +1157,7 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) #endif #if defined(CONFIG_460EX) || defined(CONFIG_460GT) - mtdcr (malrxctp8r, hw_p->rx); + mtdcr (malrxctp8r, hw_p->rx_phys); /* set RX buffer size */ mtdcr (malrcbs8, ENET_MAX_MTU_ALIGNED / 16); #else @@ -1160,6 +1186,26 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) mtdcr (malrcbs3, ENET_MAX_MTU_ALIGNED / 16); break; #endif /* CONFIG_440GX */ +#if defined (CONFIG_460GT) + case 2: + /* setup MAL tx & rx channel pointers */ + mtdcr (maltxbattr, 0x0); + mtdcr (malrxbattr, 0x0); + mtdcr (maltxctp2r, hw_p->tx_phys); + mtdcr (malrxctp16r, hw_p->rx_phys); + /* set RX buffer size */ + mtdcr (malrcbs16, ENET_MAX_MTU_ALIGNED / 16); + break; + case 3: + /* setup MAL tx & rx channel pointers */ + mtdcr (maltxbattr, 0x0); + mtdcr (malrxbattr, 0x0); + mtdcr (maltxctp3r, hw_p->tx_phys); + mtdcr (malrxctp24r, hw_p->rx_phys); + /* set RX buffer size */ + mtdcr (malrcbs24, ENET_MAX_MTU_ALIGNED / 16); + break; +#endif /* CONFIG_460GT */ case 0: default: /* setup MAL tx & rx channel pointers */ @@ -1866,14 +1912,22 @@ int ppc_4xx_eth_initialize (bd_t * bis) case 2: memcpy(ethaddr[eth_num + CONFIG_EMAC_NR_START], bis->bi_enet2addr, 6); +#if defined(CONFIG_460GT) + hw_addr[eth_num] = 0x300; +#else hw_addr[eth_num] = 0x400; +#endif break; #endif #ifdef CONFIG_HAS_ETH3 case 3: memcpy(ethaddr[eth_num + CONFIG_EMAC_NR_START], bis->bi_enet3addr, 6); +#if defined(CONFIG_460GT) + hw_addr[eth_num] = 0x400; +#else hw_addr[eth_num] = 0x600; +#endif break; #endif } |