diff options
Diffstat (limited to 'board/apollon/mem.c')
| -rw-r--r-- | board/apollon/mem.c | 237 |
1 files changed, 0 insertions, 237 deletions
diff --git a/board/apollon/mem.c b/board/apollon/mem.c deleted file mode 100644 index 36bf6e922..000000000 --- a/board/apollon/mem.c +++ /dev/null @@ -1,237 +0,0 @@ -/* - * (C) Copyright 2005-2007 - * Samsung Electronics, - * Kyungmin Park <kyungmin.park@samsung.com> - * - * Derived from omap2420 - * - * This program is free software; you can redistribute it and/or - * modify it under the terms of the GNU General Public License as - * published by the Free Software Foundation; either version 2 of - * the License, or (at your option) any later version. - * - * This program is distributed in the hope that it will be useful, - * but WITHOUT ANY WARRANTY; without even the implied warranty of - * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the - * GNU General Public License for more details. - * - * You should have received a copy of the GNU General Public License - * along with this program; if not, write to the Free Software - * Foundation, Inc., 59 Temple Place, Suite 330, Boston, - * MA 02111-1307 USA - */ - -#include <common.h> -#include <asm/arch/omap2420.h> -#include <asm/io.h> -#include <asm/arch/bits.h> -#include <asm/arch/mux.h> -#include <asm/arch/mem.h> -#include <asm/arch/clocks.h> -#include <asm/arch/sys_proto.h> -#include <asm/arch/sys_info.h> - -#include "mem.h" - -/************************************************************ - * sdelay() - simple spin loop. Will be constant time as - * its generally used in 12MHz bypass conditions only. This - * is necessary until timers are accessible. - * - * not inline to increase chances its in cache when called - *************************************************************/ -void sdelay(unsigned long loops) -{ - __asm__("1:\n" "subs %0, %1, #1\n" - "bne 1b":"=r" (loops):"0"(loops)); -} - -/******************************************************************** - * prcm_init() - inits clocks for PRCM as defined in clocks.h - * (config II default). - * -- called from SRAM, or Flash (using temp SRAM stack). - ********************************************************************/ -void prcm_init(void) { } - -/************************************************************************** - * make_cs1_contiguous() - for es2 and above remap cs1 behind cs0 to allow - * command line mem=xyz use all memory with out discontigious support - * compiled in. Could do it at the ATAG, but there really is two banks... - * Called as part of 2nd phase DDR init. - **************************************************************************/ -void make_cs1_contiguous(void) -{ - u32 size, a_add_low, a_add_high; - - size = get_sdr_cs_size(SDRC_CS0_OSET); - size /= SZ_32M; /* find size to offset CS1 */ - a_add_high = (size & 3) << 8; /* set up low field */ - a_add_low = (size & 0x3C) >> 2; /* set up high field */ - __raw_writel((a_add_high | a_add_low), SDRC_CS_CFG); - -} - -/******************************************************** - * mem_ok() - test used to see if timings are correct - * for a part. Helps in gussing which part - * we are currently using. - *******************************************************/ -u32 mem_ok(void) -{ - u32 val1, val2; - u32 pattern = 0x12345678; - - /* clear pos A */ - __raw_writel(0x0, OMAP2420_SDRC_CS0 + 0x400); - /* pattern to pos B */ - __raw_writel(pattern, OMAP2420_SDRC_CS0); - /* remove pattern off the bus */ - __raw_writel(0x0, OMAP2420_SDRC_CS0 + 4); - /* get pos A value */ - val1 = __raw_readl(OMAP2420_SDRC_CS0 + 0x400); - val2 = __raw_readl(OMAP2420_SDRC_CS0); /* get val2 */ - - /* see if pos A value changed */ - if ((val1 != 0) || (val2 != pattern)) - return (0); - else - return (1); -} - -/******************************************************** - * sdrc_init() - init the sdrc chip selects CS0 and CS1 - * - early init routines, called from flash or - * SRAM. - *******************************************************/ -void sdrc_init(void) -{ -#define EARLY_INIT 1 - /* only init up first bank here */ - do_sdrc_init(SDRC_CS0_OSET, EARLY_INIT); -} - -/************************************************************************* - * do_sdrc_init(): initialize the SDRAM for use. - * -called from low level code with stack only. - * -code sets up SDRAM timing and muxing for 2422 or 2420. - * -optimal settings can be placed here, or redone after i2c - * inspection of board info - * - * This is a bit ugly, but should handle all memory moduels - * used with the APOLLON. The first time though this code from s_init() - * we configure the first chip select. Later on we come back and - * will configure the 2nd chip select if it exists. - * - **************************************************************************/ -void do_sdrc_init(u32 offset, u32 early) -{ -} - -/***************************************************** - * gpmc_init(): init gpmc bus - * Init GPMC for x16, MuxMode (SDRAM in x32). - * This code can only be executed from SRAM or SDRAM. - *****************************************************/ -void gpmc_init(void) -{ - u32 mux = 0, mtype, mwidth, rev, tval; - - rev = get_cpu_rev(); - if (rev == CPU_2420_2422_ES1) - tval = 1; - else - tval = 0; /* disable bit switched meaning */ - - /* global settings */ - __raw_writel(0x10, GPMC_SYSCONFIG); /* smart idle */ - __raw_writel(0x0, GPMC_IRQENABLE); /* isr's sources masked */ - __raw_writel(tval, GPMC_TIMEOUT_CONTROL); /* timeout disable */ -#ifdef CONFIG_SYS_NAND_BOOT - /* set nWP, disable limited addr */ - __raw_writel(0x001, GPMC_CONFIG); -#else - /* set nWP, disable limited addr */ - __raw_writel(0x111, GPMC_CONFIG); -#endif - - /* discover bus connection from sysboot */ - if (is_gpmc_muxed() == GPMC_MUXED) - mux = BIT9; - mtype = get_gpmc0_type(); - mwidth = get_gpmc0_width(); - - /* setup cs0 */ - __raw_writel(0x0, GPMC_CONFIG7_0); /* disable current map */ - sdelay(1000); - -#ifdef CONFIG_SYS_NOR_BOOT - __raw_writel(APOLLON_24XX_GPMC_CONFIG1_3, GPMC_CONFIG1_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG2_3, GPMC_CONFIG2_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG3_3, GPMC_CONFIG3_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG4_3, GPMC_CONFIG4_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG5_3, GPMC_CONFIG5_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG6_3, GPMC_CONFIG6_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_3, GPMC_CONFIG7_0); -#else - __raw_writel(APOLLON_24XX_GPMC_CONFIG1_0 | mux | mtype | mwidth, - GPMC_CONFIG1_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG2_0, GPMC_CONFIG2_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG3_0, GPMC_CONFIG3_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG4_0, GPMC_CONFIG4_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG5_0, GPMC_CONFIG5_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG6_0, GPMC_CONFIG6_0); - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_0, GPMC_CONFIG7_0); -#endif - sdelay(2000); - - /* setup cs1 */ - __raw_writel(0, GPMC_CONFIG7_1); /* disable any mapping */ - sdelay(1000); - - __raw_writel(APOLLON_24XX_GPMC_CONFIG1_1, GPMC_CONFIG1_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG2_1, GPMC_CONFIG2_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG3_1, GPMC_CONFIG3_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG4_1, GPMC_CONFIG4_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG5_1, GPMC_CONFIG5_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG6_1, GPMC_CONFIG6_1); - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_1, GPMC_CONFIG7_1); - sdelay(2000); - - /* setup cs2 */ - __raw_writel(0x0, GPMC_CONFIG7_2); /* disable current map */ - sdelay(1000); - __raw_writel(APOLLON_24XX_GPMC_CONFIG1_0 | mux | mtype | mwidth, - GPMC_CONFIG1_2); - /* It's same as cs 0 */ - __raw_writel(APOLLON_24XX_GPMC_CONFIG2_0, GPMC_CONFIG2_2); - __raw_writel(APOLLON_24XX_GPMC_CONFIG3_0, GPMC_CONFIG3_2); - __raw_writel(APOLLON_24XX_GPMC_CONFIG4_0, GPMC_CONFIG4_2); - __raw_writel(APOLLON_24XX_GPMC_CONFIG5_0, GPMC_CONFIG5_2); - __raw_writel(APOLLON_24XX_GPMC_CONFIG6_0, GPMC_CONFIG6_2); -#ifdef CONFIG_SYS_NOR_BOOT - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_0, GPMC_CONFIG7_2); -#else - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_2, GPMC_CONFIG7_2); -#endif - -#ifndef CONFIG_SYS_NOR_BOOT - /* setup cs3 */ - __raw_writel(0, GPMC_CONFIG7_3); /* disable any mapping */ - sdelay(1000); - - __raw_writel(APOLLON_24XX_GPMC_CONFIG1_3, GPMC_CONFIG1_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG2_3, GPMC_CONFIG2_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG3_3, GPMC_CONFIG3_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG4_3, GPMC_CONFIG4_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG5_3, GPMC_CONFIG5_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG6_3, GPMC_CONFIG6_3); - __raw_writel(APOLLON_24XX_GPMC_CONFIG7_3, GPMC_CONFIG7_3); -#endif - -#ifndef ASYNC_NOR - __raw_writew(0xaa, (APOLLON_CS3_BASE + 0xaaa)); - __raw_writew(0x55, (APOLLON_CS3_BASE + 0x554)); - __raw_writew(0xc0, (APOLLON_CS3_BASE | SYNC_NOR_VALUE)); -#endif - sdelay(2000); -} |