diff options
| -rw-r--r-- | board/sbc8548/law.c | 3 | ||||
| -rw-r--r-- | board/sbc8548/tlb.c | 23 | ||||
| -rw-r--r-- | doc/README.sbc8548 | 8 | ||||
| -rw-r--r-- | include/configs/sbc8548.h | 10 |
4 files changed, 22 insertions, 22 deletions
diff --git a/board/sbc8548/law.c b/board/sbc8548/law.c index 5fa9db02f..febb6829c 100644 --- a/board/sbc8548/law.c +++ b/board/sbc8548/law.c @@ -36,9 +36,9 @@ * 0xe000_0000 0xe000_ffff CCSR 1M * 0xe200_0000 0xe27f_ffff PCI1 IO 8M * 0xe280_0000 0xe2ff_ffff PCIe IO 8M + * 0xec00_0000 0xefff_ffff FLASH (2nd bank) 64M * 0xf000_0000 0xf7ff_ffff SDRAM 128M * 0xf8b0_0000 0xf80f_ffff EEPROM 1M - * 0xfb80_0000 0xff7f_ffff FLASH (2nd bank) 64M * 0xff80_0000 0xffff_ffff FLASH (boot bank) 8M * * Notes: @@ -47,6 +47,7 @@ */ struct law_entry law_table[] = { + SET_LAW(CONFIG_SYS_ALT_FLASH, LAW_SIZE_64M, LAW_TRGT_IF_LBC), #ifndef CONFIG_SPD_EEPROM SET_LAW(CONFIG_SYS_DDR_SDRAM_BASE, LAW_SIZE_256M, LAW_TRGT_IF_DDR), #endif diff --git a/board/sbc8548/tlb.c b/board/sbc8548/tlb.c index bb4c05210..e9cedc7c0 100644 --- a/board/sbc8548/tlb.c +++ b/board/sbc8548/tlb.c @@ -46,12 +46,14 @@ struct fsl_e_tlb_entry tlb_table[] = { /* * TLB 0: 64M Non-cacheable, guarded - * 0xfc000000 56M 8MB -> 64MB of user flash + * 0xfc000000 56M unused * 0xff800000 8M boot FLASH + * .... or .... + * 0xfc000000 64M user flash + * * Out of reset this entry is only 4K. */ - SET_TLB_ENTRY(1, CONFIG_SYS_ALT_FLASH + 0x800000, - CONFIG_SYS_ALT_FLASH + 0x800000, + SET_TLB_ENTRY(1, 0xfc000000, 0xfc000000, MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, 0, 0, BOOKE_PAGESZ_64M, 1), @@ -103,21 +105,12 @@ struct fsl_e_tlb_entry tlb_table[] = { 0, 5, BOOKE_PAGESZ_16M, 1), /* - * TLB 6: 4M Non-cacheable, guarded - * 0xfb800000 4M 1st 4MB block of 64MB user FLASH + * TLB 6: 64M Non-cacheable, guarded + * 0xec000000 64M 64MB user FLASH */ SET_TLB_ENTRY(1, CONFIG_SYS_ALT_FLASH, CONFIG_SYS_ALT_FLASH, MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, - 0, 6, BOOKE_PAGESZ_4M, 1), - - /* - * TLB 7: 4M Non-cacheable, guarded - * 0xfbc00000 4M 2nd 4MB block of 64MB user FLASH - */ - SET_TLB_ENTRY(1, CONFIG_SYS_ALT_FLASH + 0x400000, - CONFIG_SYS_ALT_FLASH + 0x400000, - MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, - 0, 7, BOOKE_PAGESZ_4M, 1), + 0, 6, BOOKE_PAGESZ_64M, 1), }; diff --git a/doc/README.sbc8548 b/doc/README.sbc8548 index 6cbe12f1f..5fa9c9368 100644 --- a/doc/README.sbc8548 +++ b/doc/README.sbc8548 @@ -100,6 +100,9 @@ Boot flash: Sodimm flash: intel V28F128Jx, 16384x8 (4 devices) at 0xfb80_0000 + Note that this address reflects the default setting for + the JTAG debugging tools, but since the alignment is + rather inconvenient, u-boot puts it at 0xec00_0000. Jumpers: @@ -187,9 +190,12 @@ start end CS<n> width Desc. 0000_0000 0fff_ffff MCS0,1 64 DDR2 (256MB) f000_0000 f7ff_ffff CS3,4 32 LB SDRAM (128MB) f800_0000 f8b0_1fff CS5 - EPLD -fb80_0000 ff7f_ffff CS6 32 SODIMM flash (64MB) +fb80_0000 ff7f_ffff CS6 32 SODIMM flash (64MB) [*] ff80_0000 ffff_ffff CS0 8 Boot flash (8MB) +[*] fb80 represents the default programmed by WR JTAG register files, + but u-boot places the flash at either ec00 or fc00 based on JP12. + The EPLD on CS5 demuxes the following devices at the following offsets: offset size width device diff --git a/include/configs/sbc8548.h b/include/configs/sbc8548.h index 7c26207ab..cea017900 100644 --- a/include/configs/sbc8548.h +++ b/include/configs/sbc8548.h @@ -140,7 +140,7 @@ * FLASH on the Local Bus * Two banks, one 8MB the other 64MB, using the CFI driver. * Boot from BR0/OR0 bank at 0xff80_0000 - * Alternate BR6/OR6 bank at 0xfb80_0000 + * Alternate BR6/OR6 bank at 0xec00_0000 * * BR0: * Base address 0 = 0xff80_0000 = BR0[0:16] = 1111 1111 1000 0000 0 @@ -152,13 +152,13 @@ * 1111 1111 1000 0000 0000 1000 0000 0001 = ff800801 BR0 * * BR6: - * Base address 6 = 0xfb80_0000 = BR6[0:16] = 1111 1011 1000 0000 0 + * Base address 6 = 0xec00_0000 = BR6[0:16] = 1110 1100 0000 0000 0 * Port Size = 32 bits = BRx[19:20] = 11 * Use GPCM = BRx[24:26] = 000 * Valid = BRx[31] = 1 * * 0 4 8 12 16 20 24 28 - * 1111 1011 1000 0000 0001 1000 0000 0001 = fb801801 BR6 + * 1110 1100 0000 0000 0001 1000 0000 0001 = ec001801 BR6 * * OR0: * Addr Mask = 8M = OR1[0:16] = 1111 1111 1000 0000 0 @@ -186,11 +186,11 @@ */ #define CONFIG_SYS_BOOT_BLOCK 0xff800000 /* start of 8MB Flash */ -#define CONFIG_SYS_ALT_FLASH 0xfb800000 /* 64MB "user" flash */ +#define CONFIG_SYS_ALT_FLASH 0xec000000 /* 64MB "user" flash */ #define CONFIG_SYS_FLASH_BASE CONFIG_SYS_BOOT_BLOCK /* start of FLASH 16M */ #define CONFIG_SYS_BR0_PRELIM 0xff800801 -#define CONFIG_SYS_BR6_PRELIM 0xfb801801 +#define CONFIG_SYS_BR6_PRELIM 0xec001801 #define CONFIG_SYS_OR0_PRELIM 0xff806e65 #define CONFIG_SYS_OR6_PRELIM 0xfc006e65 |